Fadal - Spindle Drive - INV-0098
Regular price
$5,404.00 CAD
Couldn't load pickup availability
The INV-0098 is the Glentek flux-vector spindle drive used across the Fadal VMC line. When this drive fails, the spindle either won't run or trips on startup and the machine is down until it's replaced. This is the OEM-spec universal replacement.
Specifications ▼
Input Voltage
208–240V AC, 3-phase, 50/60 Hz
Control Type
DSP-based flux vector, closed-loop torque control
HP Range
5HP–20HP
Configuration
Rotary selector switch, no programming required
Interface
RS-232 serial, MotionMaestro software compatible (digital variants)
Fault Codes ▼
Fault Code 9
"Spindle fault line down" — the fault line to the inverter stayed low during spindle operation, signaling drive failure.
Fault Code 10
"Encoder and magnet not responding" — no proper spindle feedback response detected for longer than 3 seconds during operation.
Compatible Machines ▼
Fadal VMC 4020, 3016, 2216, 4525, 3020, 5020A, 6030, 6535, 8030, TRM Series
All models using the Glentek spindle drive architecture. Confirm your existing drive's model plate before ordering.
Important Information ▼
Usually In Stock
Configuration is set via rotary selector switch at install — no programming required. Contact us to confirm current availability and your machine's HP rating before ordering.
Also Needed For This Job ▼
Also Needed For This Job
Check the spindle amplifier while you're in the cabinet — DC Brush Amplifier AMP-0006, DC Brush Amplifier AMP-0021C, and Glentek DC Axis Motor MTR-0003 are the parts most commonly replaced alongside this drive.
